tip diameter

The final tip diameter of the fiber probe obtained from experiment was between 40~ 80nm, which was satisfied with the requirements of nondestructive measurement. And the angle of taper was at around 30 °, which might ensure the efficiency of light transmission.

实验得到的光纤探针尖端直径在40～80nm之间，符合细胞内无损测量要求，探针锥形角度大约在30°，很好地保证了光的传输效率。

Basic theory and practical application of tip variant, diameter variant and depth variant screw elements configuration are discussed.

主要讨论啮合型同向双螺杆挤出机螺杆组合中变头变径变深组合理论及其应用实例。

The influences of ply parameters, tip diameter, impact angle on the impact damage and fatigue property of laminates are analyzed by using this 3-D progressive damage whole-process analysis method. 4.

应用本文所提出的寿命预测方法，研究了铺层方式、冲头直径和冲击角度等因素对层合板冲击损伤及冲击后疲劳性能的影响规律和损伤机理。

Limitation for Maximum Tip Diameter of Flat top Chain Wheels

平顶链链轮最大顶圆直径的限制条件

To ensure giga-ohm seal between the tip of pipette and the cell membrane, it is necessary that the pipette tip, diameter in 1 to 5 μ m, is polished by heat melt stove.

为确保电极尖端与细胞膜形成十亿欧姆封接，要对直径1&5微米的电极尖端进行热抛光处理。

When the hulling cylinder speed is 25 r/ min, the diameter of steel wire is 2.3 mm, the clearance between steel wire tip and hulling cylinder is 50 mm, the quality of walnut hulling is the best.

在剥皮滚筒转速为25r/min，钢丝直径为2.3mm，物料入口处钢丝顶端与滚筒的间隙在50mm条件下，可获得较理想的作业质量。

Configuration and Application of Tip Variant, Diameter Variant and Depth Variant Screws for Co Rotating Twin Screw Extruders

同向双螺杆挤出机变头变径变深螺杆组合及其应用

We analyzed the influences of parameters like tip diameter, concentration of spinning solution and cross-linking ion on hydrogel structures.

分析研究了针尖直径、纺丝原液、交联离子浓度参数对水凝胶纤维结构的影响。

Fine thermocouple with tip diameter less than 0.02 mm was fabricated from commonly available couple wires ( diameter 0.1 mm) under the monitoring of a microscope and by way of electrochemical erosion and spark welding.

尝试在显微监视条件下通过电解腐蚀方法，用直径100μm的普通热电偶丝制作尖端直径小至10-20μm的微细偶丝，经电火花焊接形成微细热电偶。